Remote Access - Belkin ENTERPRISE Serie Guía De Instalación Rápida

P74238ea_F1DE101G-man.qxd 28-04-2003
Initial Network Configuration
7. Under Setting &
Configurations, click on
"Network". (Note: Uncheck
"DHCP" check box.)
8. Enter the desired network
settings and click on
"Apply Changes" to save
new network settings.
9. Reset the local IP address settings on the computer used for configuration
of the RIPC.
Connecting the RIPC to the Network
Connect the RIPC to the network using a straight-through RJ45 Category 5
network cable.
09:33 Page 12
INSTALLATION
12
INSTALLATION

Remote Access

Remote Access is a Java™ applet that displays the redirected screen, keyboard,
and mouse of the remote host system to which the RIPC is attached. The web
browser used for accessing the RIPC must supply a Java Runtime Environment,
version 1.1 or higher. Remote Access will perform in much the same way from
a remote location as if you were sitting directly in front of the computer itself.
You will be able to use the keyboard and mouse in the usual way, however, the
remote system will react to keyboard and mouse actions with a slight delay.
The length of the delay depends on the bandwidth of the line over which you
are connected to the RIPC. Open the applet by choosing the appropriate link
in the navigation frame of the HTML.
Bottom Part of the Remote Access Applet
The Remote Access Applet offers the following features:
Auto adjust button
If the video displayed is of bad quality or distorted in some way, press this
button and wait a few seconds while the RIPC adjusts for the best possible
video quality.
Sync
Choose this option in order to synchronize the local with the remote
mouse cursor.
Video settings
This opens a new window with elements to control the RIPC's video settings.
You can change some values related to brightness and contrast of the picture
displayed, which may improve the video quality. It is also possible to revert to
the default settings for all video modes or only the current one.
13