Geared Motor Installation; Rack Installation - Bauer CROSS5 Serie Manual De Instalación Y Mantenimiento

- Lay a concrete foundation with buried anchoring brackets
GB
and the base plate, making sure that it is pefectly level and
smooth, complying with the measurements shown in figure.
Note: if the cement area is already present, adjustable
SUPCS base can be used.
Attention: the gearmotor must be suitably raised from the
ground to avoid flooding.
SUPCS
(*) CROSSCRI
(*) CROSSCRN2
(**) CROSS7EHTC
CROSS7E
CROSS7EH
CROSS8E
X+5 (*)
60 (**)
CROSS5E
CROSS5EH
X+20 (*)
80(**)
CROSS5-7-8 - IP1747
356
406
X = 40
X = 40
OPENING
Ø55
240 (*) min 40
(**) min 100
290
OPENING
Ø50
240
(*) min 50
270

3.3 Geared motor installation

- Release the gearmotor and remove the key. Loosen the
three frontal screws and remove the casing.
- Position the gearmotor onto the base plate.
- Gearmotor adjustments
Horizontally slide the gearmotor on the slots of the anchor
brackets.
Vertically with the four levelling screws [A].
Note: while adjusting vertically, keep the motor slightly
raised above the base plate so as to allow enough space to
secure the rack and to make any subsequent adjustments,
if necessary.
X
CROSS7E
CROSS7EH
CROSS8E
CROSS5E
CROSS5EH

3.4 Rack installation

- Release the gearmotor and set the gate in the open po-
sition. Place the rack on pinion [14] and move the gate
manually to secure the rack along its full length.
- Once the rack has been secured, vertically adjust the
geared motor so as to have a gap of 2 to 3 mm between
the pinion and the rack with screws [A].
- Firmly secure the gearmotor with the nuts [F].
- Slightly lubricate the rack and pinion after assembly.
Manually check that the gate slides evenly and without
friction.
12
F
+14/-25
A P A
50
= 90
= 85