MrCool DIY Serie Manual De Instalación página 13

Refer to the following diagram to ensure proper distance from walls and ceiling:
>12cm
(4.75in)
Step 2: Attach mounting plate to wall
The mounting plate is the device on which you
will mount the indoor unit.
1. Take out the mounting plate packed
the indoor unit.
2. Place the mounting plate against the wall
in a location that meets the standards in
the Select Installation Location step. (See
Mounting Plate Dimensions for detailed
information on mounting plate sizes.)
3. Drill holes for mounting screws in places that:
Have studs and can support the weight of
the unit
4. Secure the mounting plate to the wall with
the provided screws.
5. Make sure the mounting plate is
the wall.
NOTE FOR CONCRETE OR BRICK WALLS:
If the wall is made of brick, concrete, or similar
material, drill 5mm-diameter (0.2in-diameter)
holes in the wall and insert the sleeve anchors
provided. ecure the mounting plate to
by tightening the screws directly into
anchors.
Minimum Ceiling
Clearance is
15cm (5.9in)
Greater
For Ceilings
9
Than Foot Suggested
Floor Clearance is
230cm(90.55in)
Less
For Ceilings
9
Than Foot Suggested
Floor Clearance is
230cm(78.55in)
correspond to screw
plate
against
For more details visit www.MrCool.com
Step 3: Drill wall hole for connective piping
You must drill a hole in the wall for refrigerant
piping, the drainage pipe, and the signal cable
that will connect the indoor and outdoor units.
1. Determine the location of the wall hole based
on the position of the mounting plate. Refer
to Mounting Plate Dimensions on the
next page to help you determine the optimal
position. The wall hole should be at least
90mm (3.54in) from the side of the unit, and
at a slightly lower angle to facilitate drainage.
2. Using a 90mm (3.54in) core drill, drill a hole in
the wall. Make sure that the hole is drilled at
a slight downward angle, so that the outdoor
end of the hole is lower than the indoor end
by about 5mm to 7mm (0.2-0.275in). This will
ensure proper water drainage. (See Fig. 4. 2)
3. Place the protective wall cuff in the hole. This
protects the edges of the hole and will help
seal it when you finish the installation process.
CAUTION
When drilling the wall hole, make sure to
avoid wires, plumbing, and other sensitive
components.
>12cm
(4.75in)
Fig. 4.1
Page 12