Thermor ALLURE Manual De Instalación Y De Uso página 18

4) How to install the device
The installation template is printed on the packaging.
1/ Unfasten the carton's flaps and place it
against the wall with the lower flap folded
back and resting flat on the floor. Prick out
the four drill holes though the packaging (wi-
thout drilling) and then remove the packaging.
2/ Carefully mark the drilling points with a
pencil (draw a cross, 4cm wide).
3/ Drill the four holes.
4/ Position the four hooks and screw them
tight.
5/ Attach the device and lock it in place.
Note: The pins supplied with the device
are of the standard type. In case of a parti-
cular stand, use appropriate pins.
Measurement (A) for
Power
500 W
750 W
1000 W
2
4
fitting lugs
814 mm
1114 mm
1414 mm
418 mm
3
5
16
41
60
A
447,5 mm
SOL