Loading The Tool - Bostitch MIIIFS Manual De Operación Y De Mantenimiento

LOADING THE MIII
EYE PROTECTION which conforms to ANSI specifications and provides protection against
flying particles both from the FRONT and SIDE should ALWAYS be worn by the operator
and others in the work area when connecting to air supply, loading, operating or servicing
this tool. Eye protection is required to guard against flying fasteners and debris, which
could cause severe eye injury.
The employer and/or user must ensure that proper eye protection is worn. Eye protection
equipment must conform to the requirements of the American National Standards Institute,
ANSI Z87.1 and provide both frontal and side protection. NOTE: Non-side shielded spectacles
and face shields alone do not provide adequate protection.
TO PREVENT ACCIDENTAL INJURIES:
• Never place a hand or any other part of the body in nail discharge area of tool while the air supply
is connected.
• Never point the tool at anyone else.
• Never engage in horseplay.
• Never pull the trigger unless nose is directed at the work.
• Always handle the tool with care.
• Do not pull the trigger or depress the trip mechanism while loading the tool.
MIIIFS
STAPLE LOADING:
Pull cover open. Insert stick of staples. Push cover forward until the detent pin snaps into place, locking the
cover. The tool is now ready to operate.
MIIIFN
NAIL LOADING:
Insert nails. Pull pusher assembly back to engage pusher to strip of nails. Tool is now ready to operate.
NOTE: Use only nails recommended for use in BOSTITCH MIII nailers or nails which meet the
BOSTITCH specifications.
BEFORE HANDLING OR OPERATING THIS TOOL:
I. READ AND UNDERSTAND THE WARNINGS CONTAINED IN THIS MANUAL.
II. REFER TO "TOOL SPECIFICATIONS" IN THIS MANUAL TO IDENTIFY THE
OPERATING SYSTEM ON YOUR TOOL.
-6-