Velleman-Kit VM152 Manual De Usuario página 6

transmitter & receiver settings
Transmitter
Changing the code :
1. Hold SW1 (left button)
2. Briefly press the 'program'-button (SW3) 3 times. The LED will flash 3 times.
3. Release SW1.
4. Your unique 32-bit code has been generated and stored.
Return to the default code :
1. Hold SW1 (left button).
2. Hold the 'program'-button (SW3). After +/- 10s the led will flash 5 times.
3. Release both buttons.
4. Your code has been reset to the default code.
Receiver: remove all learned remotes from memory and return to default code

Turn off the power (disconnect power supply)

Hold buttons 3 & 4 pressed

Turn on power (connect power supply)

The Led's start flashing

Release buttons 3 & 4 after the LED's turn off

This process takes about 10 seconds.

If the button is released before the LED's turn off, the memory will not be cleared.

The unit will now respond to the default code only.
default code.
6
please also reset the transmitter to the
SW1 LED
SW2
SW3
3 4