Operation And Cleaning; Using The Grater; Using The Mincer; Dismantling The Mincing Set - Fimar TR22/RSX Manual De Uso Y Mantenimiento

Using the grater

•
In combined mincer-grater models, remove the mincer set before using the grater.
•
Lift the grater lever and place the product to be processed inside the grater mouth.
•
Lower the grater lever and turn the switch on position "I".
•
Gradually press the lever until the product is finished.
•
In order to stop the machine, turn the switch on position "0".
•
At the end of processing lift the lever and introduce more product into the grater mouth; lower the lever
once more and turn the switch on position "I".
•
At the end of the work session turn the switch on position "0".
•
At the end of the work cycle, grate a piece of hard bread or use the appropriate brush to clean the roller.

Using the mincer

•
In combined grater-mincer versions, lower the grater lever.
•
Rotate the knobs.
•
Tighten the handwheel on the output mouth of the mincer without blocking.
•
Start-up the machine by turning the switch on position "I".
•
Place the product inside the upper mincer mouth and press it down using the pestle supplied.
•
At the end of the work session turn the switch on position "0".
•
At the end of the work cycle remove the mincer set and wash using suitable detergents in hot water or in
the dishwasher.
Dismantling the mincer set
•
Remove the hopper from the upper mouth.
•
Turn the handwheel anti-clockwise.
•
Extract
the mincing plate;
-
the blade;
-
and the volute in sequence
-
•
Rotate the mincer body-blocking knob and
extract mincer body.
•
Perform operations in reverse order to
reassemble mincer group.
•
Remove the hopper from the upper mouth.
•
Turn the handwheel anti-clockwise.
•
Extract
the mincing plate;
-
the blade;
-
and the volute in sequence
-
•
Rotate the mincer body-blocking knob and
extract mincer body.
•
Perform operations in reverse order to
reassemble mincer group.
INFORMATION: Prior to each work cycle ensure that the removable parts are properly fixed
OPERATION AND
to the machine.
CLEANING
3