Installation And Connections - Niko 05-711 Manual Del Usuario

05-711

2. INSTALLATION AND CONNECTIONS

The 1-10V analog control is 4U wide and can be mounted in a DIN-rail
cabinet. Connect the control to the 'control connection terminals' (see
fig.1). You can choose from 3 control modes + an additional panic
button control:
- analog 0-10V control: connection between a COM terminal and
terminal 0-10V+
- 1-button control with push buttons: connection between a COM
terminal and terminal 1
Connect the 1-button control between a COM terminal and terminal
1 and terminal 2 to use light atmospheres.
- 2-button control with push buttons: connection between a COM
terminal, terminal 1 and terminal 2
- panic key control: connection between a COM terminal and terminal 3
Three COM terminals are available. They can be used arbitrarily.
For the wiring diagrams, see at the end of this manual.
56 EN