Niko 05-711 Manual Del Usuario página 59

05-711
- Press the 'program' key for >2s. This does not affect the connected
lighting.
- Put the analog control in the section 'input' of the programming mode:
LED 'input' blinks.
- Repeatedly press the 'select' button briefly to select the next control
mode. The selected control mode is indicated by the corresponding
control mode LEDs (see following diagram).
> 2s.
prog
In programming mode, the 'control mode' LEDs have the following
meaning:
LED status meaning
Selection of 0-10V control (mode 1)
Selection of 1-button control (mode 2)
Selection of 2-button operation (mode 3)
Press the programming button >2s to save the settings and exit the
programming mode.
EN
select
select
select
59