Zagg Flex Arc Instrucción página 3

Retract
right earbud
1. To turn your Flex Arc on, press and hold the Power button for three
seconds. The first time you power on and pair it, you will need to hold
the Power button down for five seconds. Your Flex Arc will sound a
power up tone and vibrate to indicate it is powered on.
2. The LED, located on the left side by the Power button, will begin
flashing red and blue indicating your Flex Arc is on and in pairing
mode. Access your device's Bluetooth® settings and ensure Bluetooth
is turned on.
3. Select "ZAGG Flex Arc" from your device's list of available Bluetooth
devices. Complete any additional pairing steps based on your device.
The LED will flash blue every five seconds while your Flex Arc is on and
connected.
4. Press and hold the Power button for three seconds to turn your Flex
Arc off. When it powers off, it will vibrate twice and you will hear a
power down tone; the LED will also flash red until it is powered off.
Volume down/
Track back
Play/Pause
Volume up/
Track forward
Power/Pair/
Change modes
Retract
left earbud
2