Unpack & Assemble Filters; Important - Friedrich AP260 Manual Del Propietário

UNPACK AND ASSEMBLE FILTERS
IMPORTANT: Before you use your Air Purifier, you must remove all filters,
remove the plastic packaging from each and place them back into your unit.
Note: Make sure the side marked "FRONT" with the white tags are facing outward.
1. Remove front panel by gently pulling the top part of the front panel towards you. Then lift the hooks at the
bottom of the panel out of the bottom of the appliance.
2. Remove the Antibacterial Pre-filter by putting your fingers in the two flanges and pull the filter towards
you.
3. Remove all filters with plastic packaging from your Air Purifier.
4. Remove all plastic packaging from each filter.
5. Place optional Activated Carbon Filter (black with honeycomb markings) back into your Air Purifier.
6. Place High Performance HEPA Filter (thick white filter with black border) back into your Air Purifier.
7. Place Antibacterial/Antifungal Multi-filter (Green) back into your Air Purifier.
8. Place Antibacterial Pre-filter back into your Air Purifier.
9. Reattach the front panel. Insert the bottom hooks into the bottom of the appliance first, then push the
panel against the body of the appliance.
Step 1
Step 6
Once plastic has been removed from each filter and they are properly
4
Step 2
Step 7
placed back into your unit, you can begin operation.
Step 3 Step 4
Step 8
Step 5
Step 9