Black and Decker Li2000 Manual De Instrucciones página 8

FORWARD/REVERSE/LOCK-OFF SLIDER
• When the forward / reverse slider (1) is in the central
position the tool is locked off to prevent accidental
actuation or battery discharge.
OPERATING IN MANUAL MODE
• Rotate the collar to the position marked
in figure G.
• Use the tool as any conventional non-powered
screwdriver. When the forward / reverse slider (1) is
in the central position the tool is locked off to prevent
accidental actuation or battery discharge.
NOTE: If the collar fails to move past the cental lock position
to manual mode then please see the following procedure:
1. Turn clutch collar to Power Mode . (figure G1)
2. Run the unit.
4. Turn clutch collar to Manual Mode . (figure G1)
SCREW DRIVING
• Before installing bits, move the forward/ reverse
slider (1) to the center "lock-off" position.
• Insert the appropriate hex shank screwdriver bit into
the spindle.
• Select forward or reverse rotation.
DRILLING
• Before installing bits, move the forward/ reverse slider (1) to
the center "lock-off" position.
• Insert the appropriate hex shank drill bit.
• Select forward rotation.
NOTE: When drilling, the bit may become disconnected from the spindle upon
withdrawing it from the material. Should this occur, the bit can be removed by
re-inserting the hex shank into the spindle and running the tool in the reverse direction.
GENERAL DRILLING TIPS
• This tool is not recommended for drilling in masonry.
• Use sharp drill bits only.
• Drill bits for metal can be used for drilling holes in wood. These bits must be sharp and
should be pulled out frequently when drilling to clear chips from the flutes.
• Support and secure work properly, as instructed in the safety Instructions.
• Use appropriate and required safety equipment, as instructed in the safety instructions.
• Secure and maintain work area, as instructed in the safety instructions.
• Apply pressure in a straight line with the bit. Use enough pressure to keep the bit biting
but not so much as to stall the motor or deflect the bit.
• Hold the tool firmly to control its twisting action.
• DO NOT CLICK THE TRIGGER OF A STALLED TOOL OFF AND ON IN AN ATTEMPT
TO START IT. DAMAGE TO THE TOOL CAN RESULT.
• Minimize stalling on breakthrough by reducing pressure and slowly drilling through last part of hole.
• Keep the motor running while pulling the bit out of a drilled hole. This will help reduce jamming.
• Make sure switch turns tool on and off.
WARNING: It is important to support work properly and to hold the tool firmly to prevent
loss of control which could cause personal injury.
Use only mild soap and damp cloth to clean the tool. Never let any liquid get inside the
tool; never immerse any part of the tool into a liquid.
IMPORTANT: To assure product SAFETY and RELIABILITY, repairs, maintenance and
adjustment (other than those listed in this manual) should be performed by authorized
service centers or other qualified service personnel, always using identical replacement parts.
as shown
MAINTENANCE
8
F1
F
4
1
G
G1
1