JUNO TC920LED Instrucciones De Instalación

SAVE THESE INSTRUCTIONS
WARNING: For your safety, read and understand instructions completely before starting installation.
Before wiring to power supply, turn off electricity at the fuse or circuit breaker box.
NOTE: Juno recessed fixtures are designed to meet the latest NEC requirements and are listed in full compliance
with UL 1598. Before attempting installation of any recessed lighting fixture, check your local electrical building code.
This code sets the wiring standards and installation requirements for your locality and should be understood before
starting work. Use of non-Juno trims voids Juno warranty.
WARNING: Risk of fire. Do not install insulation within 3 inches of fixture sides or wiring compartment, nor above
fixture in such a manner as to entrap heat. (Fig. 1)*
* In Canada, when insulation is present, Type IC fixtures must be used.
TYPE TC FOR NON-INSULATED CEILINGS
3"
Juno Type TC fixtures are designed for installations where housing and
J-box will not come in contact with insulation. Insulation must be spaced
3" away from housing and J-box (Fig. 1). Improper fixture operation may
indicate improper insulation application.
1300 South Wolf Road • Des Plaines, IL 60018 • Phone 800-323-5068 • www.junolightinggroup.com
INSTALLATION INSTRUCTIONS
with Lutron Hi-Lume
Figure 1
TC920LED & TC922LED
®
Commercial Recessed Housing
HOUSING INSTALLATION
BUTTERFLY
BRACKET
Figure 2
Step 1. Install housing into ceiling cavity by inserting 1/2" EMT , 3/4"
or 1-1/2" C-Channel, linear flat bars or Real Nail 3 bar hangers into
butterfly style mounting brackets (Fig. 2).
Step 2. Adjust butterfly mounting brackets
by loosening the carriage adjustment
bolt so bottom of plaster ring is flush with
finished ceiling line. Mounting brackets
have total vertical adjustment of 3"
(Fig. 3).
Step 3. Follow steps under Electrical
Connection.
Step 4. Cut appropriate sized hole.*
If necessary, adjust fixture for ceiling thickness by loosening hex screws
that attach round housing to the plaster ring.
* Note: Cut 5-5/8" (for 5" housings) or 6-7/8" (for 6" housings) opening.
© 2014 Juno Lighting LLC
Driver (-L Option)
Figure 3
Hex Screws
Figure 4
Rev 5/14 P3693
CARRIAGE
BOLT
pg 1 of 4