Installing The Unit - Kathrein UFOcompact plus UFX 894 Guia De Inicio Rapido

Backplane
Control interface bit rate,
Full-Speed USB 2.0
Data interface bit rate, LVDS
Power supply
Discreet interfering signals
Pulse-type interferences,
max. amplitude
Total, σ
Long-term stability, τ > 1 min
Voltage, Ub
System data
Power consumption
Operation (2x720p50, 2x1080p50)
Temperature range
Permissible ambient temperature
Only with forced ventilation
Surface temperature when the
circuit breaker is activated
Safety cut-off
Dimensions (H x W x D)
Weight

Installing the Unit

1. Slide the UFX 894 into any available slot.
2. To transmit the baseband data to a transmodulator, IP streamer or decryption module via
backplane, arrange the UFX 894 to its right or left. Make sure that the UFX 894 is fully
inserted and that the contact is made to the backplane (the front plate of the UFX 894 is
located on the front of the base unit).
3. Fix the two thumbscrews up and down (Torx screws).
➯ The UFX 894 is automatically recognised by the UFX 800. As soon as the UFX 894
reaches the proper operating condition, the green LED is permanently on.
➯ For other operating instructions, see the USW 800 instructions for use.
Mb
Mb
mV
< 50 kHz
mV
mV
%
V
W
°C
°C
on
off
Residual power W
mm
kg
max. 1200
min. –3, max. +3
typ. 14.5; max. 18
typ. 75, max. 80
min. 50, typ. 55
265 x 36 x 220
3 / 4
max. 12
20
2
20
5
typ. 12.3
0 – 50
> 70
typ. 1.5
1.1