Adding A New User Pin In Admin Mode - iStorage DISKASHUR M2 Manual Del Usuario

Note: To immediately exit Admin Mode (solid
solid BLUE LED switches to a solid

10. Adding a New User PIN in Admin Mode

Important:
described in section 7, which imposes a minimum PIN length and whether a 'Special Character' has been used. The
Administrator can Refer to section 9 to check the user PIN restrictions.
PIN requirements:
• Must be between 7-15 digits in length
• Must not contain only repetitive numbers, e.g. (3-3-3-3-3-3-3)
• Must not contain only consecutive numbers, e.g. (1-2-3-4-5-6-7), (7-8-9-0-1-2-3-4), (7-6-5-4-3-2-1)
• The SHIFT ( ) button can be used for additional PIN combinations - e.g. SHIFT ( ) + 1 is a different value
than just 1. See section 7, 'Setting a User PIN Policy'.
To add a New User PIN, fi rst enter "Admin Mode" as described in section 5. Once the drive is in Admin Mode
(solid BLUE LED) proceed with the following steps.
1. In Admin mode press and hold down both
KEY ( ) + 3 buttons
2. Enter New User PIN and press KEY ( ) button
3. Re-enter the New User PIN and press KEY ( )
button again
Note: To immediately exit Admin Mode (solid
solid BLUE LED switches to a solid
#12
BLUE
RED LED.
The creation of a New User PIN must comply with the 'User PIN Policy' if one has been confi gured as
BLUE
RED LED.
LED), press and hold down the SHIFT ( ) button for a second - the
Solid
solid
Blinking
a single
GREEN
Blinking
rapidly blinking
BLUE
successfully confi gured
LED), press and hold down the SHIFT ( ) button for a second - the
www.istorage-uk.com
BLUE LED will change to blinking
BLUE LEDs
GREEN and solid BLUE LEDs will switch to
GREEN LED blink and then back to blinking
and solid BLUE LEDs
GREEN and solid BLUE LEDs change to a
GREEN LED and fi nally to a solid
LED indicating a New User PIN has been
GREEN and