D-Link DSR-500 Guia De Instalacion página 6

Browser
Microsoft Internet
Explorer
Mozilla Firefox
Netscape Navigator
Apple Safari
Google Chrome
Table 4. Browser Compatibility
To access the device with the WebUI:
1. Connect your workstation on the port labeled
LAN (1-4), which is pre-allocated to the LAN.
2. Ensure your workstation is configured with a
static IP address in the 192.168.10.0/24
subnet.
Note: Disable pop-up blocking software or
add the management IP address
Https://192.168.10.1 to your pop-up blocker's
allow list.
3. Launch your browser; enter the IP address for
the LAN interface. (The factory default IP
address is Https://192.168.10.1), then press
Enter.
Figure 6. Browser Address
4. Log on the Services Router Web Interface The
default log on information is:
Username: admin
Password: admin
Figure 7. Authentication Message
4  D-Link Services Router
Version
Using a Console Connection
6.0 or higher (RJ45-to-DB9 DCE)
The Services Router provides an serial port that
enables a connection to a computer or terminal
3.5 or higher
for monitoring and configuring the device. This
port is a RJ-45 connector, implemented as a
data communication terminal equipment (DCE)
9.0 or higher
connection.
4.0 and later
To use the console port connection, you need the
following equipment:
3.0 and later
1. A terminal or a computer with both a serial port
and the ability to emulate a terminal.
2. A RJ45-to-DB9 RS-232 with female connector.
(Already included in packing list)
3. If your Laptop or PC doesn't have RS-232
connector, a converter is required.
Note: DSR-500/1000 does not come with
RS-232 converter and these must be purchased
separately.
To establish a console connection:
1. Plug the RJ-45 connector of the supplied
RJ45-to-DB9 cable directly to the console port
on the Services Router.
2. Connect the other end of the cable to a
terminal or to the serial connector of a
computer running terminal emulation software.
Set the terminal emulation software as
following:
3. When you have correctly set up the terminal,
having previously followed the instructions in
section 2.3, "Connecting Power and Turn the
Device On/Off" then switch on your device.
The boot sequence appears in the terminal.
4. Once the boot sequence completes, the
command prompt is displayed, the device is
ready to be configured.
Baud rate: 115200
Data bits: 8
Parity: None
Stop bits: 1
Flow control: None