Kenmore 100.40713310 Manual De Uso Y Cuidado página 3

PREPARING TO USE YOUR
FOOD PROCESSOR
Before using the food processor, wash all parts except the Base in hot, soapy water.
Rinse dry. These parts can also be placed in the dishwasher on the top rack. Do not
put in or near the utensil basket.
CAUTION: Blades are sharp. Handle carefully.
CAUTION: NEVER place food processor's motor/base in water
or other liquids.
NOTE: DO NOT attempt to chop ice in this Food Processor; it will damage the
Bowl and dull the Chopping Blade. This unit will not whip cream, beat egg
whites to a desirable volume, grind coffee beans, spices or other items with
high oil content, or slice or shred hardboiled eggs, marshmallows,
or soft cheeses.
IMPORTANT: For your protection, this unit has an interlock system.
The Processor will not operate unless the Bowl is properly locked onto
Base and Cover is properly locked onto the Bowl. Do not attempt to operate
the unit without the Bowl, Bowl Lid, and Food Chute Lid correctly in place.
ASSEMBLING YOUR FOOD PROCESSOR
ASSEMBLY
1. Make sure the Control Knob is in the OFF position and the power cord
is unplugged.
2. Be sure Food Processor base is on a flat, dry, clean, stable surface before you
begin processing.
3. To assemble, put the Bowl on the Base by aligning the Bowl handle with the
Unlock icon on the base. Lock the Bowl onto the Base by turning the Bowl
counterclockwise until it clicks into place. Once locked, the Bowl handle will
face front and center (see Fig. 1).
NOTE: There is only one position for the Bowl to lock onto the Base. The unit will not
operate if the Bowl does not lock onto the Base.
4
ASSEMBLING YOUR FOOD PROCESSOR
ASSEMBLY cont.
Fig. 2 Fig. 2a Fig. 2a
4. Place the Bowl Cover onto the Bowl. Align the arrow on the Cover with the
Unlock icon on the Bowl (see Fig. 2 , 2a and 2b). Turn the Cover counterclockwise
towards the center front until it clicks.
NOTE: There is only one position for the Bowl Cover to lock onto Bowl. The unit will not
operate if the Bowl Cover does not lock onto the Bowl, or if the Large Food Pusher is not
inserted into the Oval Food Chute.
5. There is a Food Pusher Assembly consisting of a Large and Small Pusher. Align the
raised seam running down the back of the Large Pusher with the slot in the Interlock
Start Switch. Insert the Large Pusher into the Oval Food Chute. Then insert the Small
Pusher into the Circular Food Chute in the Large Pusher. See Fig. 3 and 3a.
Fig. 3
5
Fig. 2b
Fig. 3a