Using the trimmer
NOTICE!
Use the trimmer as follows:
1. Move the trimmer
locks into place (see fig. D).
2. Use the On/Off switch
(see fig. A).
3. Slowly guide the trimmer up to the hair you intend
to cut.
Always use short strokes to cut your hair.
4. Turn the shaver off.
5. Clean the shaver as described in the chapter "Daily
cleaning after a wet shave" or "Daily cleaning after a
dry shave".
Using the travel guard
The shaver is equipped with a travel guard that pre-
vents the shaver from accidentally activating.
AFTER SALES SUPPORT
Keep in mind that the trimmer always
generates a straight cutting edge. If you
do not want a straight cutting edge, you
must hold the shaver at an angle.
For hard-to-reach areas or for very preci-
se cuts, use a comb to check the hair you
intend to trim with the trimmer and the
cut length.
14
all the way out until it audibly
5
877 368 8246
USA
Handling
to turn the shaver on
TM3Service@outlook.com
USA
21