Assembly; Assembly Procedure - Marshalltown QLT PL11C Manual De Instrucciones

assembly

Components
The Drywall Lift is shipped as several components that must be
assembled before use:
A . Tripod base assembly
B . Frame assembly, which includes a winch assembly
and standard (4-ft) telescoping lift sections
C . Cradle assembly, without its detachable crossarms
D . Two cradle crossarm assembiles

assembly proCedure

1 . Set up the tripod base:
• Set the base on the floor, resting on its casters .
• Press down on the slide yoke ring . Hold the ring down
while you swing the two forward legs out until the yoke
rings snaps into the locking hole on the bottom of the slide tube .
• To prevent the tripod base from rolling backward during assembly,
lower the backstop as shown .
2 . Set the frame assembly onto the two "V" angles
on the tripod bass, and lower the frame about 1
inch until it is secured by the angles .
before continuing, be sure the frame is pushed
all the way down and is held securely by the angles.
2
C
1
3 . Attach the handle to the winch wheel . Tighten
the nut, then back it off slightly so the handle
turns freely .
3
A
B
D
3