Marshalltown QLT PL11C Manual De Instrucciones página 6

tIlt latCh
To allow the cradle to tilt (for loading a drywall panel, or for raising the panel to a
side wall or sloped ceiling), or to remove the cradle from the frame, pivot the tilt
latch out and down . To lock the cradle onto the frame without tilting pivot the latch
up to engage the stud on the cradle .
note: When it is in the level (nontilted), the cradle will also tilt up to 10°side-to-
side .
brake arm
A spring-loaded brake holds the cradle at whatever height you raise it by
cranking the winch wheel . To lower the cradle, control the backward rota-
tion of the winch by grasping the wheel handle as you carefully raise the
brake arm to release the brake .
WInCh Wheel, handle, and post
Cranking the winch (using the wheel handle) coils or uncoils the
cable that raises or lowers the cradle .
Grasp the post for leverage when cranking the winch .
retaInInG hook
The retaining hook secures the telescoping sections inside the frame, for
transport and storage .
6