Publicidad
Kit Contents
Item Qty
Description
1
2
Conductor Wire Pins
2
1
Braid Wire Pin
3
1
Power Connection Boot
4
1
Ground Sleeve
5
1
RTV Tube
6
1
End Cap
7
1
Overcap
1
2
3
4
5
6
7
Tools Required
Warnings
Due to the risk of electrical shock, arcing and fire caused by
product damage or improper usage, installation or maintenance,
a ground-fault protection device is required.
Installation must comply with Thermon requirements and be
installed in accordance with the regulations as per the norm EN
IEC 60079-14 for hazardous areas (where applicable), or any
other applicable national and local codes.
Component approvals and performance ratings are based on the
use of Thermon specified parts only.
Keep ends of heating cable and kit components dry before and
during installation.
Power Termination Instructions
P1.
Cut and remove overjacket. Do not cut metallic braid.
P2.
Separate braid strands at edge of overjacket and pull cable
through opening in braid. Twist braid into a pigtail. Trim
ends of braid.
2.5 mm
2
6.0 mm
2
P3.
Cut and remove primary insulation jacket. Omit this step for
KSR and VSX cables.
P4.
Cut matrix core between inside edges of conductors.
Do not cut bus wire strands.
1
6
Publicidad
