Psr2 (Pse3000 - Psu3000) Basic Card - Description - CAME PS Barcode Serie Manual Del Usuario

10
PSR2 (PSE3000 – PSU3000) basic card – description
1
2
3
4
5
6
1 - Terminals for connecting to transformer
2 - 1.6 A circuit protection fuse
3 - Barcode printer connector
4 - 3.15 A line protection fuse
5 - Terminals for powering * 230V a.c. card
6 - Terminals for connecting power to internal heating unit
7 - Thermostat contact to monitor heating unit (see p. 44)
8 - 24V a.c. output
9 - Ticket request button contact
10 - Terminals for connecting the magnetic coil (only on PSE
units to enable tokens)
11 - Terminals for connecting up to PSCAR1 (PSE/PSU/PSC
Display) card
12 - Terminals for connecting out-of-tickets photocell
The minimum, double insulated, cable section, depends on the characteristics and dimensions of the system, and must
not be less than 2.5 mm². Before connecting up the device, cut off the mains power supply.
* Make sure you have a proper omnipolar cut off device, with more than 3mm distance between the power
PS BARCODE -
23
8
7
sectioned-contacts
Hardware and wiring
20
22 21
19
9
10 11
13 - Terminals for connecting to the RBMP1 or to another
PSR2 or to a REM
14 - Terminals for connecting the devices that need to be
commanded (i.e. automations)
15 - Connection to TSP00 sensors
16 - Connectors for (R700) signal decoding cards
17 - Scanner reader connector
18 - 10-way Dip Switch selector
19 - "Circuit On" warning LED light
20 - 2-way Dip Switch selector - NB: do not change the
default setting (Dip-switch 1=ON; Dip-switch 2=OFF)
21 - (PSC3000) Coin reader connector; (PSE) micro switch
22 - Card power source warning LED light
23 - Barcode printer connector
18
12 13
17
16
15
14