Dtt Cooling Unit Assembly (Installation) - Pfannenberg DTT 6401 Serie Instrucciones De Servicio

GB
3.4.2

DTT cooling unit assembly (installation)

2
1
Item Designation
1 Unit contour
Make cut-outs for the DTT cooling unit
Requirements
- All general requirements are fulfilled, see
- The cooling unit is de-energized.
Required tools and material
- Saw
- Use a switch cabinet cutter, if applicable
- Protective covers
Procedure
 Use a protective cover to protect the switch cabinet from chips.
 Provide the switch cabinet with cut-outs and holes. For the prescribed dimensions, refer to the figure
the DTT cooling unit.
 Deburr the cut edges.
 Remove chips and assembly waste from the switch cabinet.

Cut-outs and holes have been made.
Operating Manual DTT 6401 Standard Controller (SC) 086100036 © Pfannenberg GmbH
Figure16 – DTT switch cabinet cut-out
Item
2
General assembly requirements
Designation
Cut-out angle
2
cut-outs for
Page 18 / 42