Domnick Hunter PNEUDRI MiDAS Manual De Instrucciones página 10

2.5 RUNNING THE DRYER WITH A MINIMUM PRESSURE ABOVE 7 BAR
If the dryer is to be run with a minimum pressure of 7 Bar g (102psig) an alteration to
the timer board is required.
To carry out the alteration,ensure the electrical supply is isolated, lie the dryer on its
back, to gain access to the control base. Remove the large plate to gain access to the
timer board. Move electric jumper from Position 1 to Position 2, as shown.
Position 1
Dryers running below
7 Bar g (102psig)
Position 2
Dryers running above
7 Bar g (102psig)
8