Hosdecora VERS-100 Manual De Utilización Y Mantenimiento página 8

Table of parameters
Showcase's parameters has been adjusted previously for a correct an optimal performance.
If you need to change any parameter:
1. Press the SET button for 8 seconds then the E1 parameter is displayed
2. Use the arrows to select the value desired
3. Press the SET button to store the new values and to move to next parameter.
If no buttons are pressed after 10 seconds the controller exits the adjusting window.
Message
E1
E2
E3
E4
E5
E6
F1
F2
F3
F4
Troubleshooting - What to do in case of:
If your showcase develops a fault, please check the following table before making a call to your
distributor or technical service.
Problem
The showase doesnt work
Parameter
Maximum temperature value
Minimum temperature value
Temperature buffer
Delay of temperature buffer
Fix parameter
Fix parameter
Defrosting time
Desfrost periods
Defrost temperature
Temperature Units selection
The unit is not switched on
Plug and lead are damaged
Power supply
Internal wiring fault
Factory value
Possibble Cause
7
2ºC
6ºC
4ºC
3 min
0
00
25 min
6 horas
20ºC
ºC
You must do
Check the unit is plugged in
correctly and switched on
Call a qualified Technician
Check power supply
Call a qualified technician
Range
0ºC a 2ºC
2 a 45ºC
1 a 10ºC
0 - 10 min
-
-
1 - 60min
1 -24 hrs
0 - 22ºC
ºC