Operation - Bostitch BTMT72393 Manual De Operación Y De Mantenimiento

DO NOT ATTEMPTTO UNCLOG (BACK
FLUSH) SPRAY GUN BY SQUEEZING
TRIGGER WHILE HOLDING FINGER IN FRONT OF FLUID
NOZZLE.
PRESSURE MAY VARY ACCORDING
TO VISCOSITY OF MATERIAL USED.
MAXIMUM WORKING PRESSURE OF GUN IS 50 PSI.
DO NOT EXCEED PRESSURE LIMIT OF GUN OR ANY
OTHER COMPONENT IN SYSTEM!
PRIOR TO DAILY OPERATION, MAKE
CERTAIN THAT ALL CONNECTIONS
AND FITTINGS ARE SECURE. CHECK HOSE AND ALL
CONNECTIONS FOR A WEAK OR WORN CONDITION
THAT COULD RENDER SYSTEM UNSAFE. ALL
REPLACEMENT COMPONENTS SUCH AS HOSE
OR FITTINGS MUST HAVE A WORKING PRESSURE
EQUAL TO OR GREATER THAN SYSTEM PRESSURE.
Prior to shipment, this gun was treated with an
anticorrosive agent. Before using this gun make sure
that it is carefully flushed with thinner.
1. The position of the air cap (H) horns will determine
the spray pattern. Loosen (G) air cap and rotate horns
to achieve desired pattern.Tighten air cap.
2. Attach paint cup to the gun.
NOTE: The (F) filter supplied is optional to protect
against contaminants and small particles. See parts
list for filter orientation.
3. Attach air supply line to 1/4 NPS air inlet.
NEVER point spray gun at self or any other person.
Accidental discharge of material may result in serious injury.
4. Adjust air pressure at air compressor.
DO NOT exceed 50 psi.
5. Depress spray gun trigger fully to spray material.
NOTE: Depressing trigger partially will cause only air to be released.
ADjUST SPRAY GUN:
a. Amount of material released (density of "fan spray") is controlled
by (D) fluid control knob . Turn knob counterclockwise to increase, or
clockwise to decrease, the fluid flow.
b. Width of "fan spray" is governed by (B) spray pattern control knob. Turn knob counter-clockwise to
increase, or clockwise to decrease, air flow.
c. Air quantity is controlled by (C) air-volume control knob. Turn knob counterclockwise to increase, or
clockwise to decrease, the air flow.
NOTE: Care should be exercised when handling spray gun to avoid damage to the orifice of the air cap
and tip of fluid nozzle. Damage to these parts results in irregular spray patterns.
(E) Non-Drip Cup
(F) Material
Filter
(H) Horns
(G) Air Cap
(A) Air
Valve Nut
- 7 -

OPERATION

(D) Fluid
Control
Knob
(B) Spray
Pattern
Adjustment
(C) Air
Volume
Control Knob
Horizontal position
Vertical position