Mounting Brackets; Mm Nylock Nuts; Wiring Cover Screws - Haiku FR127A-A2 Guia De Instalacion

Install Mounting Brackets
4
Raise the fan to the mount. Insert one rubber bumper between
the mounting plate and the loosely installed mounting bracket
with the 6 mm nylock nuts.
Secure the other bumper with the remaining mounting bracket
and nuts (Fig. 4).
Tighten all hardware.
Fig. 4
Mounting
Bracket
6 mm Nylock
Nut
20
Install Wiring Cover
5
Raise the wiring cover, allowing about a 1/8" (3 mm) gap at the
ceiling. Align the mounting slots with the screw holes on the
extension tube, and secure it with the wiring cover screws.
Slide the trim up the extension tube, aligning the tabs on the
inside with the slots on the bottom of the wiring cover. Twist
clockwise to snap the trim into position (Fig. 5).
Fig. 5
Wiring
Cover
Screw
Wiring Cover
Trim
REV. A
Screw
| © 2018 BIG ASS FANS | ALL RIGHTS RESERVED