Tabla de contenido
Publicidad
MODELO DEL LAVABO GUIJARRO SOPORTE ARRIBA
#007-307-XXX
PEBBLE DROP-IN SINK MODEL #007-307-XXX
Especificaciones del producto
(Todas las medidas en milímetros a menos que se)
• Cuenca Dimensiones: 431.8 x 355.6
• Borde: Piso
• Altura: 152.4
• Profundidad: 139.7
• Agujero de drenaje: 44.45
• Centrado en el agujero de drenaje
• Grueso de cristal: 12.7
• Peso: 6.35kg
• Instalación en el mostrador
• Plantilla proporcionada
Códigos/Estándares Aplicables
Modelo especificado reúne o excede las siguientes:
•
IAPMO / UPC y CUPC
•
IAPMO / CSA
412.75
Borde superior: 28.58
Por debajo de la llanta: 22.35
28.58
355.6
431.88
495.3
Drop-In Installation Instructions:
Template included with sink:
Templates are supplied only as a guideline. The physical use of the
sink will assure an accurate cut-out.
Level
Tools and Materials:
1. Inspect sink prior to installation. No returns accepted after installation unless
product is mechanically defected.
2. Provide your countertop manufacturer with your lavatory template (provided),
to assist in your granite cut-out. Templates are supplied only as a guideline,
the physical use of the sink will assure an accurate cut-out. JSG Oceana takes
no responsibility for inaccurate cutting of the granite.
3. Prior to installation, pre-install the drain to lavatory.
4. Clean the top-side of the countertop and the underneath rim of the lavatory.
5. Apply a clear epoxy/caulking to the under/outer rim of the drop-in and place
into countertop cut-out.
6. Verify that the lavatory is level. If the lavatory is not level, gently press down
on the lavatory.
7. Wipe away excess sealant and allow sealant time to set, according to sealant
manufacturer's instructions.
8. Complete the water supply and drain connections.
9. Run water into the lavatory and check for leaks.
19 ½"
1 ¾" Drain hole
6"
Sealant
Sealant
Countertop
Sealant
Sink
Countertop
Publicidad
Tabla de contenido
