Unpacking And Content; Assembly & Adjustment - POWER SMITH PWLR1110F Manual Del Operario

UNPACKING AND CONTENT

IMPORTANT
faulty or that a part is missing. If you find anything wrong, do not operate the product until the
parts have been replaced or the fault has been rectified. Failure to do so could result in serious
personal injury.
CONTENTS IN PACKAGE
Description
Work Light
120V AC Power Charger
Operator's Manual
ASSEMBLY & ADJUSTMENT
ADJUSTING THE WORK LIGHT (FIG 2)
This work light is fully assembled out of the box. It can be unfolded
to a standing postion, or be folded to a flat storage positon. See
FIG 2.
NOTE:
The maximum turn angle between the frame and base is
limited. There are marks on the adjustable joint (5) showing the
turning limits. Do not over force it when unfolding the light.
ADJUSTING THE LIGHT DIRECTION
Your work light tilts 360°.
To Adjust the Light Direction,
CHARGING/RECHARGING THE WORK LIGHT (FIG 3)
This rechargeable work light is shipped with the battery partially charged. Charge the work light after purchase and
before the first use by using the 120V AC charger (12) for 3-5 hours or until the battery charge indicator turns green.
Charging/Recharging Using the 120V AC Charger
1. Make sure the work light is turned off.
2. Connect the 120V AC power charger and the charging port
(10) as shown in FIG 3.
3. Plug the AC charger into a standard 120V/60Hz power outlet
to start charging. A lit red "PowerSmith" logo (A) indicates the
charging is in progress. The "PowerSmith" logo turns green
when the charging is completed.
When "PowerSmith" logo (A) turns red and flashing while the light is in use, it indicates the battery power is less
than 15%, it is time to charge the light.
ON/OFF SWITCH (FIG 1)
The work light is equipped with an ON/OFF switch (7). Press the switch once to turn the work light on and press the
switch a second time to turn it off.
NOTE:
The work light is always on its brightest setting when switched on.
!
Due to modern mass production techniques, it is unlikely the product is
QTY
1
1
1
simply rotate the work light head to desired position.
OPERATION
English
4
12
10
a
FIG 3
FIG 2