Twin-Star International 28MM6240 Manual De Instrucciones Adjunto página 5

PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare parts with
package contents list and diagram above. If any part is missing or damaged, do not attempt to
assemble, install or operate the product. Contact customer service for replacement parts.
Estimated Assembly Time: 60 Minutes
Tools Required for Assembly (not included): Phillips head screwdriver, scissors and utility knife
ASSEMBLY INSTRUCTIONS
1. To remove the drawer, fully extend the drawer out
and locate the black plastic levers located on the
metal glide tracks of the drawer box. At the same
time, push opposite on the plastic lever while gently
pulling the drawer out from the cabinet to disengage
the drawer box from the glide. Set the drawer aside.
2. Locate the Left Side Cabinet (B), Right Side Cabinet
(C), Center Front Bar (D), and set out face down on
a scratch-free surface.
Insert one Wood Dowel (CC) into each of the
pre-drilled holes.
Push the Left Side Cabinet (B) and Right Side
Cabinet (C) snug to the Center Front Bar (D). Make
sure the Wood Dowels (CC) are seated in the
pre-drilled holes.
Connect the Left Side Cabinet (B), Right Side
Cabinet (C ) and Center Front Bar (D) with
connection plate, tighten Screws (EE) through the
pre-drilled holes.
HAND TIGHTEN ONLY.
Hardware Used
CC Wood Dowel
EE Screw
Fig. 1
Fig. 2
x 4
x 2
4
B
CC
D
CC
EE
B
C
C