Alder USV-6-80T Manual De Servicio página 72

(MSDS: 722330)
Other Protective Equipment: A source of clean water should be available in the work
area for flushing eyes and skin. Impervious clothing should be worn as needed.
Suggestions for the use of specific protective materials are based on readily available published
data. Users should check with specific manufacturers to confirm the performance of their products.
9. PHYSICAL AND CHEMICAL PROPERTIES
Note: Unless otherwise stated, values are determined at 20°C (68°F) and 760 mm Hg (1 atm).
Appearance: Clear and bright
Physical State: Liquid
Odor: Mild petroleum
pH: Not applicable
Vapor Pressure (mm Hg): <1
Vapor Density (air=1): >1
Boiling Point/Range: No Data
Freezing/Melting Point: <-27°F / <-33°C
Solubility in Water: Negligible
Specific Gravity: 0.855-0.871
Percent Volatile: Negligible
Evaporation Rate (nBuAc=1): Negligible
Viscosity: 22-68 cSt @ 40°C / 4.3-8.7 cSt @ 100°C
Bulk Density: 7.13-7.26 lb/gal
Flash Point: >384°F / >196°C (COC)
Flammable/Explosive Limits (%):
10. STABILITY AND REACTIVITY
Stability: Stable under normal ambient and anticipated storage and handling conditions of temperature and
pressure.
Conditions To Avoid:
Materials to Avoid (Incompatible Materials):
agents.
Hazardous Decomposition Products:
phosphorus, and zinc oxides.
Hazardous Polymerization:
11. TOXICOLOGICAL INFORMATION
Lubricant Base Oil (Petroleum) (CAS# Various)
Carcinogenicity: The petroleum base oils contained in this product have been highly refined by
a variety of processes including solvent extraction, hydrotreating, and dewaxing to remove aromatics and
improve performance characteristics. None of the oils used are listed as a carcinogen by NTP, IARC, or
OSHA.
12. ECOLOGICAL INFORMATION
Not evaluated at this time
Página 60
No Data
Extended exposure to high temperatures can cause decomposition.
Avoid contact with strong oxidizing
Combustion can yield carbon, nitrogen, sulfur,
Will not occur.
Page 5 of 7
Manual de servicio USV-6-80T