Instructions For Use / English; Description Of Functions; Power Off; Important Usage Notes - therm-ic SuperMax Powerpack Modo De Empleo

INSTRUCTIONS FOR USE / ENGLISH

Charging procedure
Each Powerpack has an LED that shows the charge
status (see table).
LED Description
on charging
blinking charging complete
(maintenance charging)
Important: First, connect the charger to the socket.
Attach both Powerpacks to the charging cable. The
charging process begins automatically (the correspon-
ding LED turns on).
The Powerpacks are automatically monitored and
turned off by the integrated electronics, regardless of
the charge status. After successful charging (max. 4
hours), the Powerpacks are automatically switched to
maintenance charging mode (the corresponding LED
will blink).
In case of an error, the charging process is automatically
stopped after 5 hours.
10
D ES C RI P T I ON OF F U NC TI O NS
The Supermax Powerpacks have two operating modes:
POWER OFF - IN USE
These modes are clearly indicated on the device display
(red LED):

POWER OFF:

The level switch is set to level "0". The device display
(red LED) remains off. The Powerpack is now complete-
ly switched off.
IN USE:
The Powerpack is supplying the connected Therm-ic
sole with power. Each Powerpack can be individually set
to 3 different heat levels. The device display (red LED)
turns on.
I MP ORTA NT US A GE NO TE S
When using the heating element cable, plug it into
the Powerpack until it can be clearly felt to engage.
When using the unit, do not allow level 3 to be
switched on longer than a few minutes at a time.
Otherwise too much heat can be produced during
operation, which could lead to burns.
Always set Powerpacks to level 1 or 2 to maintain
a comfortable level of warmth for your feet (heating
should be almost undetectable).
The optimum heat output is reached when your
shoes and soles are dry.
U SE A N D F U N C TI O N S
The desired heat level can be individually set for each
Powerpack using the level switch (levels 1, 2, 3).
H EAT LE V EL S
Level Average Heating period per
temperature (°C/°F) battery charge up to
37°C/99°F
1 18 hours
45°C/113°F
2 8.5 hours
3 70°C/158°F 3 hours
SE RV IC E, S T OR A G E A ND CA R E
O F TH E P O WER PA CK S
To provide for long product life, store the Powerpacks
fully charged, turned off (level "0") and disconnected
from heating insoles and the charger in a dry place at
room temperature. Clean the parts as needed with a
soft, slightly damp cloth and a mild cleanser.
ATTENTION: Always remove the charger from the outlet
before cleaning it.
MET H O DS FO R AT TA C H IN G
TH E P O WER PA CK S
Attach the Powerpack to the outer edge of a shoe
with the wire clip (Fig. 1.1).
Additional accessories are also available at your local
dealer. This allows you to attach the Powerpacks to as
follows:
Use Therm-ic Velcro Straps to attach the powerpacks
to a shoe or your lower leg (Fig. 1.2).
11