Nostalgia Products CCM600 Instrucciones Y Recetas página 11

5. Place the new Extractor Head with wires attached onto the shaft and replace center bolt.
6. Tighten the center bolt using the #1 Wrench (K).
CHANGING THE KRYPTOL
The Kryptol is the connection point that powers the heating element on the extractor
head. The electricity from the machine transmits heat through the Kryptol which allows
the Extractor Head to get hot and melt the sugar. Eventually the Kryptol wears down
with continued use of the OLD FASHIONED COMMERCIAL COTTON CANDY MAKER,
and needs to be replaced. Follow the directions below when changing the Kryptol:
1. Before replacing the Kryptol, make sure that the machine is turned OFF,
unplugged, and the Extractor Head has cooled completely.
2. Use the Screwdriver to remove all screws from the collar and remove collar.
9