GPI GM Serie Guía De Operaciónes página 5

Input: Turbine Mounted Display or Conditioned Signal Sensor (See inputs from Diagram 1) Standard Remote Sensor
(See inputs from Diagram 2) Output: Customer Equipment, 0-5 V Sensing, Separate Loop Power Supply
GPI.G2-Series.Turbine.
(See.Diagrams.1.or.2)
NOTE..1:. Loop.power.supply.electrically.isolated
. from.customer.equipment
NOTE..2:. Actual.value.of.loop.current.(mA).is
. disregarded
Input: Turbine Mounted Display or Conditioned Signal Sensor (See inputs from Diagram 1) Standard Remote Sensor
(See inputs from Diagram 2) Output: Customer Equipment, Frequency Sensing, Separate Loop Power Supply
GPI.G2-Series.Turbine.
(See.Diagrams.1.or.2)
NOTE..1:. Loop.power.supply.electrically.isolated
. from.customer.equipment
NOTE..2:. Actual.value.of.loop.current.(mA).is
. disregarded
W I R I N G D I A G R A M 4
— 0-5 V Output —
Customer Equipment Without Built-in Power Supply
INPUTS OUTPUTS
GPI.4-20.mA
Transmitter
W I R I N G D I A G R A M 5
— Pulse Output —
Customer Equipment Without Built-in Power Supply
INPUTS OUTPUTS
GPI.4-20.mA
Transmitter
Loop.Power.Supply
Typ.12..–..24.VDC
(–)
(+)
Loop.(+)
(current)
Loop.(–)
(current)
0-5.V.Output
Local.Com
CAUTION:. When. reassembling. the. faceplate,.
Loop.Power.Supply
Typ.12..–..24.VDC
(–)
(+)
Loop.(+)
(current)
Loop.(–)
(current)
Pulse.Out
Local.Com
CAUTION:. When. reassembling. the. faceplate,.
Customer.Equipment
0-5.V.Analog.Input.(+)
Analog.In.Return.(–)
make.sure.that.the.enclosure.seal.is.not.
crimped.or.twisted..Do.not.over-tighten.
corner.screws.(hand.tighten.only)..Face-
plate.can.be.rotated.90°.
Customer.Equipment
Open-Collector.Pulse.In
Pulse-In.Return
make.sure.that.the.enclosure.seal.is.not.
crimped.or.twisted..Do.not.over-tighten.
corner.screws.(hand.tighten.only)..Face-
plate.can.be.rotated.90°.
5