Returning For Service - DeFelsko PosiTest Manual De Usuario

Before returning the PosiTest LPD for service –
1. Install new or fully recharged batteries in the proper alignment.
2. Examine all wires, plugs and connectors for damage.
3. Ensure the test sponge is properly moistened.
4. Re-attempt measurement.
IMPORTANT:
please fill out and include the Service Form located at
www.defelsko.com/support with the detector. Be sure to also include
your company name, company contact, telephone number and fax
number or email address.
Limited Warranty, Sole Remedy
Limited Warranty, Sole Remedy
DeFelsko's sole warranty, remedy, and liability are the express
limited warranty, remedy, and limited liability that are set forth on its
website: www.defelsko.com/terms.
© DeFelsko Corporation USA 2016 All Rights Reserved
This manual is copyrighted with all rights reserved and may not be
reproduced or transmitted, in whole or part, by any means, without written
permission from DeFelsko Corporation.
DeFelsko and PosiTest are trademarks of DeFelsko Corporation registered
in the U.S. and in other countries. Other brand or product names are
trademarks or registered trademarks of their respective holders.
Every effort has been made to ensure that the information in this manual is
accurate. DeFelsko is not responsible for printing or clerical errors.

Returning for Service

Returning for Service
If you must return the PosiTest LPD for service,
and Limited Liability
and Limited Liability
www.defelsko.com
13