Inserting The Batteries; Opening Door - hjh OFFICE SAFE COMPACT III Manual Del Usuario

OPENING YOUR SAFE FOR THE FIRST TIME
To open the safe for the first time, please use the emergency key. The operation in details refer to
"opening the safe with the emergency key".
• Remove emergency lock cover, then insert the emergency key, and turn it counterclockwise.
• Turn the knob (master key) clockwise to open the door.
CAUTION: Finish operation, pull out the emergency key and keep it in a safe place.

INSERTING THE BATTERIES

• Open the door.
• Insert 4 X AA batteries into the battery compartment.
• Under normal condition both red and green lights are on at the same time. It means the volta-
ge is low and you should insert new batteries.
CAUTION: Replace 4 batteries by lining them up in a manner as indicated by the "+ "and " - "
signs. You should reset the user's code after replacing the batteries.

OPENING DOOR

• Input your user's code (3 to 8 digits), each press results in one beep and the yellow light flas-
hes.
• Press „A" (C/#) or „B" (E/*) Confirming button, the green light will be on.
• Rotate the knob (master key) clockwise and pull outwards within 5 seconds, the door is ope-
ned.
CAUTION: The user preset code is "159". Please input the user code again if the yellow light flas-
hes with beeps.
EN
3