Alarm Demonstration; Setting The Display Brightness - Philips HF3470 Manual De Instrucciones

EnglisH
10
setting the alarm sound (HF3470 only)
See section 'Menu functions' above.
You can choose one of the following sounds:
- Radio (Fig. 16)
- Birds (Fig. 17)
- Beep (Fig. 18)
snoozing
1 Push down the control lever to the bottom position when the alarm goes off. (Fig. 19)
The lamp continues to be on at the selected intensity level, but the alarm sound stops. After
,
9 minutes, the wake-up sound is automatically played again.
Note: The 9-minute snooze time is fixed. This time cannot be adjusted.
Note: If you push down the control lever with too much force, it may jump back to off position.

alarm demonstration

If you want to get a quick demonstration (60 seconds) of the gradually increasing light level and
sound level, activate the test function of the appliance.
1 Push the control lever down to the bottom position for a few seconds until TEST appears on
the display (Fig. 20).
2 Push the control lever down again to stop the demonstration.
Note: The appliance continues to run the alarm demonstration until you push down the control lever
again. The test automatically stops after 9 hours.
radio/volume (HF3470 only)
1 To switch on the radio, press the radio on/off button. (Fig. 21)
2 To select the desired radio frequency, press the menu + and - button. (Fig. 9)
Tip: To scan radio frequencies automatically, press and hold the menu + or - button for approx. 2 seconds.
Tip: To make sure you get a good radio signal, fully unwind the antenna and move it around until you
have found a position at which reception is best.
3 To switch off the radio, press the radio on/off button again.
volume
1 To set the volume, press the volume increase or decrease button. (Fig. 22)
HF3470: You can choose a volume level between 1 and 20. HF3465: You can choose a volume
level between 1 and 10.
Note: The volume level you have selected is automatically set as the volume level for the alarm as well.

setting the display brightness

1 Press the MENU button to enter the menu (Fig. 8).
2 Press the menu + or - button to select the display brightness menu (Fig. 9).
3 Press the SELECT button to enter the display brightness menu (Fig. 10).
4 Press the menu + and - button to change the display brightness (Fig. 9).
5 Press SELECT to confirm (Fig. 10).