DISPLAY
Cool •
Energy •
Saver
Fan •
Timer •
TEMP O
(-TIMER
- SHUT-OFF TIME
• You will usuallyuseshut-offtimewhileyou sleep.
• With unitrunning,useTLmer to set numberof hours
untilshut-off.
• Foryoursleepingcomfort,once Time is set,the
Temperaturesettingwillraise2°F after30 rain.,
and 2°F afteranother 30 min.
• Everytime you pushTimer button,it advancesthe
Timer settingas follows:1 Hour_ 2 Hours.....
12 Hoursmaximum.
- START TIME
• With unit not running, use Timer to set number of
hours before until starts.
• Every time you push Timer button, it advances the
Timer setting as follows: 1 Hour -, 2 Hours -, •.....
12 Hours maximum.
REMOTE CONTROL SIGNAL
RECEIVER
JRE SETTING
• Usethisbutton to automatically c ontrol the
temperature ofthe room.
The temperature canbe setwithin a range
of60°F to86°F byincrements o f I°F.
POWER
• To turnthe air conditioner ON, pushthis
button.
To rum the air conditioner O FF, pushthe
buttonagain.
• This buttontakes priority over anyother
button.
• When you first turnit on,the unitis in
coolmode, Highfan speed,Temperature
settingat 72°F.
-- FAN SPEED
• Everytimeyou pushthis button, i t
advancesthesetting as follows:
{High-_ Low-_ Med -_ High}
MODE
- Everytimeyou pushthis button,it willshiftamongCOOL, ENERGY SAVER and FAN.
- ENERGY SAVER:
• The fan stopswhenthe compressor stopscooling. Approximately every3 minutesthefan willtum on and
the unitwillcheckthe roomair to determineif coolingis needed.
_d
after an electrical power failure, the unit willbegin to run at its last setting.
1
-14-