Kenmore 580.73093 Manual Del Propietário página 7

PROCEDURE A
n If you are using a new Kenmore folding sleeve
with your unit, skip to step 3, Otherwise, install
the plastic grille from the kit. Cut the plastic
grille to 25-1/2" wide and 15-1/4" high. Place
the plastic grille to the inside of the wall sleeve
at the rear flange.
FIG. 3
_'_ Fasten the 4 washer screws to secure the grille
to the wall sleeve. If you need plastic nuts to
mount plastic grille to the inside of the wall
sleeve, there are plastic nuts in the installation
kit. The nuts are installed from the inside of the
sleeve and are pressed into the square holes of
the rear flanges.
or
FIG. 4
_]_ Install the new unit into the wall sleeve.
_---! To assemble trim, snap the tab of each piece
into the slot of the other piece as shown below.
Slide trim over the front of the air conditioner
until trim is flush with sleeve as shown below.
I
I
Trim (2 ea)
Wall
FIG. 6
_J Remove the backing from the Horizontal
Insulation strip 13/ex 3/8x 273_1s and attach that
to the inside bottom of the sJeeve as shown
below. Remove the backing from the Around
Insulation strip 13_8 x 3_4 x 611/2 and attach that
to the inside front of the sleeve as shown
below.
FIG. 5
• Air conditioners covered in this manualpose
an excessive weighthazard. Two or more
people are needed to move and installthe unit.
To preventin ury or strain, use properlifting
and carry ng technques when movng un t.
• When handlingthe air conditioner,be careful
to avoid cutsfrom sharp metalfins on front and
rear coils.
• Make sure air conditionerdoes not fall during
removal.
-7-