D-Link DSR-250 Guia De Instalacion página 31

About This Guide
This guide gives step by step instructions for
setting up D-Link DSR-250 Services Router.
Please note that the model you have purchased
may appear slightly different from those shown in
the illustrations.
Unpacking the Product
Open the shipping carton and carefully unpack its
contents. Please consult the packing list located
in following information to make sure all items are
present and undamaged. If any item is missing
or damaged, please contact your local D-Link
reseller for replacement.
- One (1) DSR-250 Unified Services Router
Appliance
- One (1) 12V/1.5A Power Adapter
- One (1) Console Cable (RJ45-to-DB9 Cable)
- One (1) Ethernet (CAT5 UTP/Straight Through)
Cable
- One (1) Reference CD (CD-ROM containing
product documentation in PDF format)
Product Overview
This chapter provides detailed descriptions of the
DSR-250 device and its components.
Front Panel - DSR-250
A B C
Figure 1. DSR-250 Front Panel
Item Feature
A
B
C
D
E
Table 1: DSR-250 Front Panel Descriptions
Device Status LEDs and Ethernet Port LEDs
The device LEDs show information about current
device status. When the device power up, the
POWER/STATUS LED will show solid orange
during power on process. Startup takes one minute
approximately to complete, the LED will change
to solid green. If you want to turn the device off
and on again, we recommend you wait a few
seconds between shutting it down and powering it
back. The Ethernet LEDs show the status of each
Ethernet port. Table 2 lists the name, color, status
and description of each device LED.
D E
Description
LED Power LED: Indicates the Services
Router is powered on.
(Top to bottom)
USB Port (1) It can support various USB 1.1 or
2.0 devices below:
1.Flash Disk or Hard Disk for
network sharing.
2.WCN Configuration (It will be
supported by future firmware
upgrade)
3.Printer (It will be supported by
future firmware upgrade)
Gigabit LAN port Connect Ethernet devices, such as
computers, switches and hubs.
(1-8)
Gigabit WAN One auto MDI/MDIX WAN ports
are the connection for the Ethernet
port (1)
cable to the cable or DSL modem.
Console Port (1) Used to access Command Line
Interface (CLI) via RJ45-to-DB9
console Cable.
Link
Speed
Figure 2. Ethernet RJ-45 Port LEDs
D-Link Unified Services Router  31
TX/RX
Status