Surtek 107102 Instructivo Y Garantia página 5

1. Turn knurled handle until the zero graduation
on the belivel edge of the knurled handle is lined
up with the vertical mark on the case, and is even
with the 480 in-lb graduation.
2. Turn knurled handle until 1 graduation on the
beveled edge of the handle is in line with the
vertical line on the case.
3. Lock handle securely by tuning lock nut
clock-wise. Wrench is now set al 504 in-lb. Torque
and is ready to use see fig.2.
• When setting for metric (kg-m), use name
procedures as setting for in-lb.
• Install the proper socket or attachment to the
square drive and apply to nut or boit and pull
handle until you feel and/or hear wrench click.
Release pull and wrench automatically reset for
next operation. Do not continue to pull after
wrench releases. Use special care at low torque
setting that pull stops when wrench clicks.
CAUTION
1. If wrench has not been or has been in stored for
some time, operate it several times at a low torque
setting which allow special internal lubricant to
recoat internal working parts.
2. When wrench is not in use, keep adjustment at
lowest torque setting.
3. Do not turn handle below lowest torque setting.
4. So not continue pulling on the wrench after
pre-set torque has been reached and the wrench
released. Pressure must be taken off the handle
and the wrench allowed to automatically reset it
self, continuing to apply pressure after the wrench
has released, will result in damage to the part
being toque by applying more than the specified
amount of torque.
5. Tool is rugged and designed for shop use, but, is
also a precision measuring instrument and should
be treated as such.