Ingersoll Rand ELB2612N Especificaciones Del Producto página 4

EN
(Dwg. 45595618-4)
The spring can be easily replaced by removing the torque adjustment ring cover and the torque
adjustment ring at the end of the tool.
1. When replacing the spring, apply grease evenly around the outside of the spring. Failing to do
so may cause the tool to operate in an unstable manner.
2. Make sure no parts fall off when replacing the spring. If any parts fall off it may cause the tool
to malfunction or fail. The bearing plate must be properly aligned before mounting. Mount
the bearing plate with the bearings protruding towards the torque adjustment ring.
3. Be sure to mount the torque adjustment ring cover for torque control.
Apply Grease
(to the Outside of the Spring)
(Dwg. 45595618-5)
EN-3
4.0
3.5
3.0
2.5
2.0
1.5
1.0
0.5
0.0
1 2 3 4 5 6 7 8 9
Torque Scale
Spring Bearing Plate
Washer
High Torque Spring
Low Torque Spring
(Accessories)
Bearings protruding
from the Bearing Plate
Torque Adjustment
Ring Cover
Torque
Adjustment Ring
45549110_ed1