Introduction; Features; Controls; Front Panel - SYSTEMS DMP801 Manual Del Usuario

DMP801

INTRODUCTION

Congratulations on your purchase of a DMP801 Automatic Mixer� The DMP801 provides a simple, effective way to
maintain your audio levels in live venues without having to keep on your toes� A single DMP 801 offers eight-in, one-out
support and the entire unit can be controlled remotely through standard potentiometers and remote controls� Internal
processing is accomplished through a high quality 40-bit floating point processor, with internal signal processors and
signal routing all handled with ease�
Clear, easy-to-use software on your Windows computer makes control of your onboard processing simple� The software
offers full performance monitoring for each processor, giving real-time information on the load placed upon DSPs�
We know how eager you are to get started – hooking up your new DMP801 is probably your first priority right now – but
we would advise that you take the time to look over this manual. Inside you'll find important safety considerations and
operating instructions that could prove helpful� After reading the manual, we would suggest putting it somewhere easy to
find as you will probably need to refer to it later on.

FEATURES

8 input channels available via 3-pin Euroblock connections
●
Ethernet connectivity for network control application
●
Easy and intuitive control software from ASystems
●
User-accounts with multi-layer security
●
4-band parametric EQs and 31-band graphic equalizers
●
● Autoleveler (Loudness Control)
Compressors and noise gates
●
● Level ducking with trigger control
All signal processors flexible and user-controllable
●

CONTROLS

FRONT PANEL

1.
Input Level Control Knob 1 - 8 Every input channel is
equipped with a rotary knob for adjusting the final input
level�
2. IN LED
Every input channel is equipped with an IN LED which
lights green when a signal is present in the input
channel, and flashes red when the signal clips.
3. MIX OUTPUT LED
The Mix Output LED will light up green when an output
signal is present and flash red when the output signal
clips�
English
4. POWER LED
This LED indicator will illuminate when the DMP801 is
activated�
5. Power Switch
Flick this switch to switch the unit on or put it on standby�
6. Mounting Holes
These holes are for mounting the DMP801 on a standard
19" rack�
7. DISABLE LED
This LED will light up when the power switch is disabled
through the control software�
2