Rover HVE High Volume Extraction
The Rover HVE is a high-performance extractor designed for commercial use
R E A D A N D S A V E T H E S E I N S T R U C T I O N S
Safety Information
WARNING
ELECTRIC SHOCK HAZARD
WARNING! Unit must be grounded.
Insert 3-prong plug on power cord into an electrically
grounded outlet
Do not use adaptor
Never cut off third prong
WARNING! Keep motor and wiring dry.
Do not operate in more than ½ inch of standing water.
Do not operate in rain or snow. Use indoors only.
Do not use hose or pressure washer to clean electrical
compartment. Follow cleaning instructions in manual.
If electrical components become wet, allow them to dry
before using.
WARNING! Unplug unit before servicing.
WARNING! Wait for electricity to dissipate before opening
control box.
WARNING! Do not alter or modify your Rover HVE in any
way. Use only replacement parts authorized by Dri-Eaz
Products, Inc. Modifications or use of unapproved parts
could create a hazard and will void your warranty. Contact
your authorized Dri-Eaz distributor for assistance.
SAFETY INSTRUCTIONS
•
Read and understand manual before operating.
•
Be careful not to run over, catch, or damage the cord.
•
Turn off all controls before unplugging. Unplug when
not in use. Do not unplug cord by pulling on cord;
instead pull on plug only.
•
Look out for obstructions or hazards before backing up
or turning, use extra care when near stairs. Keep Chil-
dren Away: Do not allow children to play with or around
the unit. Be sure the unit is inaccessible to children
when not attended.
07-01549B 2012-06 Warranty 07-00422
Owner's Manual
DRI-EAZ PRODUCTS, INC.
15180 Josh Wilson Road, Burlington, WA USA 98233
Fax: (360) 757-7950 Phone US: (360) 757-7776
in restorative drying, to extract water from flooded carpet and carpet pad.
Patents: http://www.LBpatents.com
www.dri-eaz.com
INTRODUCTION
The Rover HVE is a high-pressure volume extractor for commer-
cial use in water damage or flood damage restoration. It maxim-
izes water removal from all kinds of carpet to facilitate faster dry-
ing.
The Rover HVE utilizes a replaceable polymer glide head with a
smooth, self-healing edge that easily glides over the carpet. The
Rover is propelled by two 0.15 HP electric motors through opera-
tion of the joystick.
• Separate drive wheels allow the Rover HVE to maneuver
around corners with ease.
• Replaceable polymer glide moves smoothly over all
carpets
• The joystick is rated for 10 million cycles.
• Two-speed switch optimizes extraction effectiveness.
• Collapsible handle for space-saving storage and ease of
transport.
• Front loading wheels make it easy to transport the
Rover HVE from the van to the job and back.
• LED light illuminates the floor in front of the Rover HVE.
• Extraction can be visually monitored through the clear take-
up tube.
PARTS INDENTIFICATION
Hi/lo switch
Calibration but-
ton
On/off
button
Light
Front
transport
wheels
for loading
Replaceable
polymer
glide
Stainless steel
vacuum head
1
(Shown, below)
Joystick
Molded-in
handlebars
Circuit breaker
Clear take-up tube
Footpad
Rotomolded deck
Tethered locking pin
Dri-Eaz Products, Inc.
Urethane
plastic
traction
wheels