Dri-Eaz F354 El Manual Del Propietario

Dri-Eaz Rover High Volume Extraction (HVE)
The Rover HVE is a high-performance extractor designed for commercial use
R E A D A N D S A V E T H E S E I N S T R U C T I O N S
Safety Information
WARNING
ELECTRIC SHOCK HAZARD
WARNING! Unit must be grounded.

Insert 3-prong plug on power cord into an electrically
grounded outlet

Do not use adaptor

Never cut off third prong
WARNING! Keep motor and wiring dry.

Do not operate in more than ½ inch of standing water.

Do not operate in rain or snow. Use indoors only.

Do not use hose or pressure washer to clean electrical
compartment. Follow cleaning instructions in manual.

If electrical components become wet, allow them to dry
before using.
WARNING! Unplug unit before servicing.
WARNING! Wait for electricity to dissipate before opening
control box.
SAFETY INSTRUCTIONS
•
Read and understand manual before operating.
•
Be careful not to run over, catch, or damage the cord.
•
Turn off all controls before unplugging. Unplug when
not in use. Do not unplug cord by pulling on cord;
instead pull on plug only.
•
Look out for obstructions or hazards before backing up
or turning, use extra care when near stairs. Keep Child-
ren Away: Do not allow children to play with or around
the unit. Be sure the unit is inaccessible to children
when not attended.
07-01549 F 2011-07 Warranty 07-00422
F354 Owner's Manual
DRI-EAZ PRODUCTS, INC.
15180 Josh Wilson Road, Burlington, WA USA 98233
Fax: (360) 757-7950 Phone US: (360) 757-7776
in restorative drying, to extract water from flooded carpet and carpet pad.
Issued/Pending Patents: May be covered by US6,355,112; and/or CA2,600,604
www.dri-eaz.com
INTRODUCTION
The Rover HVE is a high-pressure volume extractor for commer-
cial use in water damage or flood damage restoration. It max-
imizes water removal from all kinds of carpet to facilitate faster
drying.
The Rover HVE utilizes a replaceable polymer glide head with a
smooth, self-healing edge that easily glides over the carpet. The
Rover is propelled by two 0.15 HP electric motors through opera-
tion of the joystick.
• Separate drive wheels allow the Rover HVE to maneuver
around corners with ease.
• Replaceable polymer glide moves smoothly over all
carpets
• The joystick is rated for 10 million cycles.
• Two-speed switch optimizes extraction effectiveness.
• Collapsible handle for space-saving storage and ease of
transport.
• Front loading wheels make it easy to transport the
Rover HVE from the van to the job and back.
• LED light illuminates the floor in front of the Rover HVE.
• Extraction can be visually monitored through the clear take-
up tube.
PARTS INDENTIFICATION
Hi/lo switch
Calibration
button
On/off
button
Light
Front
transport
wheels
for loading
Replaceable
polymer
glide
Stainless steel
vacuum head
1
(Shown, below)
Joystick
Molded-in
handlebars
Circuit breaker
Clear take-up tube
Footpad
Rotomolded deck
Tethered locking pin
Dri-Eaz Products, Inc.
Urethane
plastic
traction
wheels