Chauvet DJ CH-02 Guía De Referencia Rápida página 5

CH-02 QRG
Description
Assembly
Instructions
The CH-02 is a heavy-duty aluminum T-bar stand with side bar supports,
8 optional mounting points, and quick release pins for easy setup and
teardown. The CH-02 is great for mobile DJs and entertainers.
To assemble the CH-02, refer to the diagrams on the following pages and
do the following:
Figure 1:
1. Loosen lower knob on the tripod assembly.
2. Open the tripod legs and place the product on the floor
(or level surface) so the center shaft is vertical.
3. Tighten the lower knob on the tripod to secure it.
4. Loosen the upper knobs on the center shaft.
5. Extend the inner tube of the center shaft.
6. Tighten the upper knobs on the center shaft to secure the tube in place.
Figure 2:
7. Assemble the supported side bars. See
Assemblies and T-bar and Side Bars Finished View
information and close-up views.
8. Slide the supported side bars assembly over the shaft and secure it at
the desired height by tightening the bolts.
Note: Be sure to tighten all the bolts of the side bars assembly.
Figure 3:
9. Assemble the T-bar with supports. See
Assemblies and T-bar and Side Bars Finished View
information and close-up views.
10. Slide the T-bar with supports over the top of the shaft and secure it
into place by tightening bolts.
Note: Be sure to tighten all bolts of the T-bar assembly.
T-bar and Side Bars
T-bar and Side Bars
5
EN
for more
for more