Switch Housing Assembly; Testing Your Fan - Craftmade AT52 Manual De Instrucciones

9. Switch Housing Assembly.

Remove 3 screws from switch housing plate.
Connect male plug from fan to female plug
from switch housing, matching up the colors
on the male plug with the colors on the
female plug for correct fit. Be sure that the
plugs connect completely.
Align holes in switch housing with holes in
switch housing plate. Re-insert screws that
were just removed and securely tighten all 3
screws with a Phillips screwdriver.

10. Testing Your Fan.

It is recommended that you test fan before
finalizing installation. Restore power from circuit
box and light switch (if applicable). Test fan
speeds with pull chain. (diagram 1) Start at the
OFF position (no blade movement). First pull will
set the fan to HI. Second pull will set the fan to
MEDIUM. Third pull will set the fan to LOW. Fourth
pull will again set the fan to the OFF setting. If fan
does not function, please refer to
"Troubleshooting" section to solve any issues
before contacting Customer Service.
Turn fan completely off before moving the reverse
switch. Set reverse switch to recirculate air
depending on the season:
- LEFT position in summer (diagram 2)
- RIGHT position in winter (diagram 3)
A ceiling fan will allow you to raise your
thermostat setting in summer and lower your
thermostat setting in winter without feeling a
difference in your comfort.
Important: Reverse switch must be set either
completely to the LEFT or completely to the RIGHT
for fan to function. If the reverse switch is set in
the middle position (diagram 4), fan will not
operate.
Attach pull chain extension supplied or custom
pull chain extension (sold separately) to the end
of the pull chain.
motor housing
switch
housing
plate
diagram 1
diagram 2
page 7
male plug
female plug
switch housing
reverse
switch
pull chain
extension
diagram 3 diagram 4