Light Kit Assembly (Optional) - Craftmade AT52 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

11. Light Kit Assembly (Optional).

WARNING: Failure to disconnect power supply at
main panel prior to light kit assembly may result in
serious injury.
IF YOU WISH TO USE YOUR FAN WITH A LIGHT
KIT (sold separately), remove 3 screws from
switch housing plate. (Refer to diagram a.)
Punch center cap out of switch housing with a
screwdriver. (Refer to diagram b.) Remove hex
nut and lock washer from threaded rod on light
kit fitter. Push wires from light kit fitter (one by
one) through hole in middle of switch housing
and screw switch housing onto threaded rod
followed by lock washer and hex nut that were
previously removed. Tighten hex nut over lock
washer for a secure fit. (Refer to diagram c.)
Connect WHITE wire from light kit fitter to
WHITE wire from switch housing. Connect
BLACK wire from light kit fitter to BLUE (or
BLACK) wire from switch housing. Be sure
molex connections snap together securely.
(Refer to diagram c.)
Connect female plug from switch housing to
male plug from motor housing, matching up
the colors on the male plug with the colors on
the female plug for correct fit. Make sure plugs
connect completely.
Align holes in switch housing with holes in
switch housing plate. Re-insert screws that were
previously removed and securely tighten all 3
screws.
Attach glass shade(s) to light kit fitter using the
hardware provided with the light kit. (Refer to
diagram d.)
NOTE: If you are installing a bowl fixture, the
bulb(s) must be installed first.
Install bulb(s) specified by the light kit. (Refer to
diagram d.) If you are installing a halogen bulb,
be sure not to handle glass directly with your
fingers as oil from the skin may shorten the life of
the bulb.
IMPORTANT: When changing bulb(s),
remember to allow bulb(s) and glass shade(s) to
cool before touching.
diagram a
switch housing
diagram b
hex nut
lock washer
switch housing
diagram c
bulb
[representative only]
diagram d
page 8
motor housing
switch housing
plate
center cap
molex
connections
BLACK
BLUE (or BLACK)
WHITE
WHITE
light kit fitter
[representative only
for using threaded
rod to attach light kit]
light kit
fitter
[representative only]
glass shade
[representative only]

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido