During Use; Extinguishing The Flame; Storage And Transport Conditions - Kemper oxikit 555C Manual Del Usuario

the appliance when leaking, damaged or malfunctioning. If you detect a leak in the equipment (gas smell), bring
it immediately outside, in a well-ventilated area with no flammable sources, where you can find and stop the leak.

DURING USE:

- Always extinguish the flame before placing torch on a surface.
- Ensure that flexible hose is not bent
- NEVER point the flame towards containers (they should never get hot), flexible hoses (they can burn) and to
yourself or other people.
- Do not operate the equipment in space-constrained sites.
- The structure of the device must work on a horizontal surface
- Use the equipment outside or in a well-ventilated place
- Work only in a safe and clean area, away froml oily and combustible materials, and fire hazards.
- Wear necessary equipment for eyes protection.
- Do not wear clothes greasy dirty.
- Avoid inhaling welding/brazing fumes.
- It is recommended to wear protective gloves that avoid burns when handling hot materials and equipment;
allow the welded material and the components to cool down before touching or moving them to a different
location.
- Given the possibility of projection of overheated material, it is recommended to use gowns or aprons for the
protection of the body.
- Do not try to move the equipment by pulling the hoses.
Some instructions on how to use cylinders:
Cylinders are pressure containers of flammable material and special attention needs to be paid when using them,
in particular:
- Do not expose to direct sun rays and temperatures over 50°C.
- Do not pierce or burn after use
- Discard only when completely empty
- Do not spray over hot or incandescent material.
- The oxygen cylinders 571 and 570 are disposable units, so DO NOT refill them.
- The oxygen cylinder 585H200 is rechargeable. It must therefore be recharged only by the supplier; filling done
differently can lead to serious accidents.

EXTINGUISHING THE FLAME:

For temporary interruptions of work:
- To extinguish the flame, always close the gas stopcock first, then close the oxygen stopcock located on the
torch grip.
- Do not maintain the pipes under pressure
- Allow the torch to cool down before touching it or placing it on a surface; always place the nozzle on
appropriate non-flammable stand.
For storing the equipment for a long time:
- To stop gas flow, close the screw located on the gas cylinder inlet valve.
- Close the gas stopcock located on the torch grip.
- Close the oxygen stopcock
- Disconnect containers
- Maintain cylinders always in vertical position

STORAGE AND TRANSPORT CONDITIONS

- Disconnect containers if the equipment is not used for a long time period or in case of transport with vehicle.
- Ensure containers are always in a vertical position during storage and transport operations.
- Keep away from children
MAINTENANCE
- Use only original replacement parts
- Never use the equipment if any components appear damaged
- IMPORTANT NOTE: do not carry out any type of operations on single parts of the appliance; it may result in
serious risks for the user. If the equipment does not function properly, contact your local sale representative or
KEMPER's support service – Via Prampolini 1/Q – 43044 Lemignano di Collecchio (PR) – Tel +39 0521 957111 –
Fax +39 0521 957195
- Carefully follow instructions provided during maintenance operations.
- 10 -