Wellstore Jet Pool Cleaner Instrucciones De Uso página 6

SETTING THE CLEANING PATTERN
Your Jet cleaner is pre-set to scan and clean most pools from 70 feet ( 24 m) to 80 feet ( 27 m) in length. The Jet cleaner is factory set
to look like the picture in Fig.16 with one Lock pin installed on each side. The Jet cleaner will systematically clean your pool in a
consistent pattern.
After your Jet cleaner completes its cleaning cycle, remove the cleaner from the pool and transfer the lock-pins from the right side of
the unit to the left side (vice-versa) Next time you use your Jet cleaner the cleaning unit will clean the pool in the opposite pattern.
This will ensure that your cleaner completely cleans your pool.
16
Lockpin in
preset position
Curves counter
clockwise in this
direction
Adjustable
axle
Fixed
axle
Goes straight
in this direction
18
Lockpin in
forward position
Adjustable
Lock Pin
axle
Fixed
axle
17
6
ADJUSTING THE CLEANER
FOR YOUR POOL
Curves on a
greater angle in
The cleaner uses a systematic
this direction
cleaning pattern that allows the
cleaner to go back and fourth in
overlapping patterns. The cleaner
may be used to clean a variety of
different size pools, from the small, to
the very large. Before its first use, you
must set up the cleaner for your pool.
To adjust the cleaner you will use the
axle locking pin. (Fig. 17). There are
two locking pins permanently
attached to the unit with a lanyard.
Only one locking pin is required for
Goes straight
in this direction most applications. For the very large
pools you will need to install an
additional locking pin (Located on the
jet valve housing). Follow the pin
configuration illustration for your size
pool (Fig. 18).